Panasonic AG-HPX500 Service Manual

Also see for AG-HPX500: Brochure & specs Operating instructions Menu information

Contents

Panasonic AG-HPX500 Service Manual Manual pdf 49 page image

INF-398. UID Writing Procedure< PREPARATION >When UID is written, the PC EVR software is used. Please connect the tools and set up the PC EVR softwarefollow the item “6. PC EVR software”.< Writing Procedures >1. This camera recorder is set to CAM mode.2. Select “SYSCON(S)” section after start up the PC EVR software, and click “OK” button.3. Select “Write UID” in “Tools(W)” menu, Write UID screen will appear on screen.4. Input the last 8 figure numbers in “UID P2” box. When the last 8 figure numbers are noted in advance, inputthe same numbers as noted ones. If the last 8 figures are missed, new numbers are given. So please contactthe Panasonic Service Engineering.5. Click “WRITE” button, the writing starts and following message is displayed.6. Click “OK” button.NOTE: In case of write “SBP2 UID”, write UID follow the step 4 to 6 (Input the last 8 figure numbers in “SBP2UID” box.).7. Click “Re-Boot power” button on Write UID screen, the power of camera recorder automatically OFF and ON.The operation of power OFF/ ON is required to save the number into the camera recorderNOTE: When the “UID P2” and “SBP2 UID” are written at the same time, it is not necessary to perform the powersupply is OFF and ON individually.8. Open the DIAGNOSTIC menu and confirm that the UID has been written in correctly.