– 5 –– 4 –English1. IntroductionGeneralThisis a compact AC geared-motor having multiple international standard certifications. To use thisproduct for a prolonged period, read this manual thoroughly.This is designed for use in corporation with general purpose industrial devices. The product mustbe handled by experienced personnel familiar with the product.When export this product, follow statutory provisions of the destination country.Unpacking• Proceed as follows:• First open the top of the packing and check the units for damage in transit.• Check the motor nameplate for the model number, output, No. of poles, voltage, frequency,etc.Do not use the product if it does not meet your specification (if you dare to use it, burninjury or fire may result).• A single-phase motor comes with capacitor and capacitor cap. Check the rated capacitanceand voltage on the nameplate. Do not use the accessory capacitor if it does not meet yourspecification (if you dare to use it, you may be injuried or may have fire).• Gear head is optional.• Check a gear ratio on the nameplate. Do not use it if it does not meet your specification (if youdare to use it, you may be injuried or may have fire).Don't put an object or finger into the motoropening.Don't turn off and on power so frequently.Don't pull leadwires with an excessive force.Don't use the equipment in highly intensiveelectric field.Don't use the equipment under direct sunshine.Don't use the equipment in an environment whereelectro-static voltage potentials may be produced.Don't drop or cause topple over of somethingduring transportation or installation.Never attempt to perform modification,dismantle or repair.Perform installation by taking intoconsideration the mass of the body and ratedoutput of the product.Adjust the motor ambient environmentalcondition to match the motor operatingtemperature and humidity.Exactly follow the installing method anddirection specified.Connect a ground-fault interrupter, circuit breakerand replay to the brake control relay in series sothat they are turned off upon emergency stop.Test-run the securely fixed motor withoutloading to verify normal operation, and thenconnect it to the mechanical system.Level of input voltage to peripheral devicesshould correspond to the motor rated voltage.Provide protection device against idling ofelectro-magnetic brake or gear head, orgrease leakage from gear head.Don't place any obstacle object around themotor and peripheral, which blocks air passage.Correctly run and arrange wiring.Maintenance must be performed by anexperienced personnel.Always keep power disconnected when thepower is not necessary for a long time.Scraps must be treated as industrial waste.Failure to heed this instruction will result inelectric shock or fire.Failure to heed this instruction will result infire, personal injury, malfunction or damage.Failure to heed this instruction will causefire, electric shock or personal injury.Failure to heed these instructions willcause personal injury or fire.Induced malfunction will causemalfunction or personal injury.Failure to heed this instruction will result inpersonal injury or malfunction.Failure to heed this instruction will result infire, electric shock, personal injury ormalfunction.Failure to heed these requirements willresult in personal injury or malfunction.Missing of one of these devices will causemalfunction.Operation using a wrong model or wrongwiring connection will result in personal injury.Operation from a voltage outside the rated voltagewill cause electric shock, personal injury or fire.No protection will cause personal injury,damage, pollution or fire.Temperature rise will cause burn injury orfire.Wrong wiring will cause personal injury orelectric shock.Improper operation will cause personalinjury.CautionShould you find any discrepancy in the product, consult your local dealer.Safety Precautions Please observe safety precautions fully.
