Installation1.First read carefully the relevant instructions in Safety and precautions .2.Place the TV set in a room where there is no direct sunlight on it. Any light reflecting from the screen will cause fatigueof your eyes.3.Use gentle indirect lighting for comfortable watching. The best distance of watching is 5~7 times the screen height.4.Keep a space of 10cm or over between the TV set and wall for good ventilation.5.Never put the TV set in a place with excessive temperature or moisture, to avoid damage or failure of its components.A color TV set is likely to be affected by magnetic fields causing color distortion. If the TV set is moved while on, turnedor affected by a magnetic object nearby, turn off the power supply and wait for at least 1 hour before turn it on. That is toensure that the automatic demagnetizing circuit will operate eliminating adverse effects of magnetism on color purity.For good reception use an outdoor antenna. The recommended type and location of antennas varies between different areas.Notes:1.Connect the outdoor antenna as shown above.2.It is suggested to use 75 coaxial cable to eliminateinterference or noise.3.The cable must not be tied together with supply cords.Automatic demagnetizingAntenna connectionParallel flat cable(300 )Impedance adaptor(300 -75 )Antenna inputPreparing the remote controller1 Remove the battery cover of remote controller.2 Load two AAA type batteries into the chamber observing the correct polarity.Precautions operating the remote controller1.Direct the remote controller to the infrared receiver window of the TV set.2.Do not press the keys on the remote controller continuously.3.If the remote controller will not be used for long time or if the batteries havedepleted, please remove them to prevent leaking.4.Never throw batteries into fire and properly dispose of the used batteries.5.Take care not to drop, damp or dismantle the remote controller.