OneStart

Menu

PaloAlto Networks M-500 Reference Manual

Also see for M-500: Quick start

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Contents
  1. contact information
  2. Table Of Contents
  3. Table Of Contents
  4. Overview
  5. Front Panel Description
  6. Back Panel Description
  7. Installing the Hardware
  8. Equipment Rack Installation
  9. Connecting Cables to the Device
  10. Maintaining the Hardware
  11. Power Supply Replacement
  12. Specifications
  13. Interface Specifications
  14. Compliance Statements
  15. General Safety Information
  16. Other Regulatory Information
PaloAlto Networks M-500 Reference Manual Manual pdf 22 page image
Power Supply Replacement22 • Maintaining the Hardware Palo Alto Networkssize : 953869 MBpartition_1 : active syncpartition_2 : active syncDisk id A2 Presentmodel : ST91000640NSsize : 953869 MBpartition_1 : spare rebuildingpartition_2 : spare rebuildingAfter the rebuild is complete, the status will show active sync for both partitions, whichcompletes the drive replacement operation.Power Supply ReplacementThe M-500 appliance has two hot-swappable redundant power supplies. If a power supplyfails, a system log alert will be generated, an audible alert will sound, and the power failureindicator described in the “Front Panel Description” on page 6 will change to amber and willflash.To replace a failed power supply:1. Identify the failed power supply and remove the power cord. The LED on the powersupply will be off or amber if it has failed.2. Push the release tab on the back of the power supply to release the power module fromthe chassis and remove it from the chassis as shown in Figure 13.Figure 13. Power Supply Replacement3. Install the new power supply ensuring that you close the release tab and then plug thepower cord back into the new power supply.4. Check that all power supply warning indicators are in their normal state.
/ 32
Related manuals for PaloAlto Networks M-500
PaloAlto Networks M-300 Quick Start Manual first page preview
PaloAlto Networks M-300 Quick Start Manual
This manual is suitable for:
M-500
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved