Menu
Octopus 44364 Installation Manual
                                            | |
Contents
| 
• Attach the steering cable to the tilleri) Rotate the steering cable rod end sothat the hole is horizontally aligned.ii) Position the steering cable rod endinto the clevis bracket (Fig B43).iii) Insert the quick release locking pinand lock in place using the hitch pin.• Refer to section B9 on connecting the secondary steering cable to the drive unit.B7d Quick ReleaseIn an emergency situation the steering cable can be quickly disconnected from thetiller by pulling out the hitch pin and then removing the locking pin.B7e SpecificationMaximum stroke .......................................................... 8.5in (216mm)Peak Thrust ................................................................. 330Ibs / 136kgMax Rudder Torque..................................................... 185ft-lb (250Nm)Hard Over Time ........................................................... 12-15 secondsPeak Power ................................................................. 60 watts 5 ampsAverage Power ............................................................ 1.25 ampsTiller arm radius ........................................................... 7.5in /190mmMax displacement........................................................ 13,200Ibs / 6,000kgMax boat length ........................................................... 32ft / 10mVoltage......................................................................... 12V DCClutch circuit power ..................................................... 850mA32 of 44Subject to change without notice OC15269 REV Fwww.octopusdrives.comwww.octopuseurope.comFig B43 - Attaching the steering cable to the tillerHitch pinQuick releaselocking pin |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved