NuAire AxTan AXH80DG-4LN Installation Manual

NuAire AxTan AXH80DG-4LN Installation Manual Manual pdf 1 page image

1Nuaire | Western Industrial Estate | Caerphilly | CF83 1NA | nuaire.co.uk 04. 04. 23. Document Number 672064AxTânFire-Rated Axial Skid AssemblyInstallation Manual1.0 SAFETY INFORMATION• The provision of the electrical supply and the connection of the unit to the electricalsupply must be carried out by a qualified electrician in accordance with latest edition ofthe wiring regulations.• Isolate from power supply before removing any covers. During installation ormaintenance ensure all covers are fitted before switching on the mains supply.• All-pole disconnection from the mains as shown in the wiring diagram must beincorporated within the fixed wiring and shall have a minimum contact separation of3mm in accordance with latest edition of the wiring regulations.• This unit must be earthed.• Ducting must be securely fixed with screws to the spigot to prevent access to liveparts. Duct runs terminating close to the fan must be adequately protected by suitableguards.• Precautions must be taken to avoid the back-flow of gases into the room from the openflue of gas or other fuel-burning appliances.• This appliance should not be used by children or persons with reduced physical,sensory or mental capabilities or lack of experience and knowledge, unless they havebeen given supervision or instruction concerning the safe use of the appliance by aperson responsible for their safety. Children shall not play with the appliance. Cleaningand user maintenance shall not be carried out by children.• Other relevant safety information including that related to PPE, transportation,installation, maintenance and operation can be found in the following instructions.1.1 Hazard SymbolsGENERAL WARNINGSignifies a general warning regarding hazard specified by supplementaryinformation.ELECTRIC SHOCKThis unit must be completely electrically isolated before any panels areremoved. Check mains supply and control connections.ROTATING PARTSThis unit contains fast moving rotational parts which may start automatically. Itis the sole responsibility of the installer to adequately guard these components.REFER TO INSTRUCTION MANUALRead and understand the installation and maintenance manual beforeinstalling, operating or maintaining this product.