Menu
Northern Industrial Tools PTO-Driven 6" Owner's Manual
            | |
WARNING: Always stop the PTO, turn off the engine and remove the key beforeperforming any inspection, maintenance, adjustments or cleaning.Lubricate: PTO shaft — 2 zerks on universals once a day with multipurpose grease. Slip Joint — Lubricate with multi-purpose grease. Feed roll pivot — 2 zerks on underside of chute end. Multipurpose grease every 4 to 8hours of operation. If dust or fine particles make pivot bind, unhook feed roll springs,use cleaning solvent on pivot while moving up and down, wipe off, lubricate slides,and replace springs. Feed roll drive-shaft — Zerk on feed roll drive-shaft lubricates both the slide and bothuniversal joints. Add multipurpose grease until grease shows at both universals every4 to 8 hours of operation, particularly before each use. Occasionally remove andthoroughly clean this assembly. Feed roll clutch — While feed roll shaft is off, lubricate the feed roll clutch inside andoutside with multipurpose grease. Gear box — Check label on the gear box for gear box lubrication. Check all bolts, set-screws and fasteners after running four hours, and once per daythereafter. Check for loose belts and broken pulleys, loose springs, dry slides and properlubrication of both feed roll drive-line and feed roll clutch. The main drive belts on the chipper need co be tight. To tighten these belts, firstloosen the four bottom nuts that hold the jack-shaft bearing. Loosen them about threeturns, then move the nuts on the top of the bearings down an equal amount. Keep thejack-shaft parallel with the main shaft. Torque the bottom nuts to 80 ft.-lbs. The belts of the main drive on the PTO chipper should be checked every 8 hours ofoperation. Look for cracks, looseness or other signs of deterioration. For best performance,replace with a matched set of eight belts. The feed roll drive belt can be adjusted by first loosening the four bolts that hold theworm gear box to the base, then moving the gear box away from the chute andre-torques the bolts to 40 ft.-lbs. All decals and safety instructions should be kept clean and legible. It is the operator’sresponsibility to replace the decals as needed (they will be mailed at no charge).TROUBLE SHOOTING |
Related manuals for Northern Industrial Tools 180100
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved