Menu
Nematron M1500 User Manual
Also see for M1500: User guide
                           | |
Contents
| 
11SERIALRS-232VGA USB"B"USBRETENTIONBRACKETDVI-DTOUCH SCREENCABLESVIDEO CABLES(AUTO ADJ)MENU DOWNSELECT UP(VGA / DVI) POWERConnection of VGA and Touch Screen CablesConnect either a 15-pin VGA or DVI-D cable and either an RS-232 or USB cable if the monitor isequipped with a touch screen. All communication cables should include a chassis ground shield.Hazardous location, Division 2, requires that all cables have adequate strain relief. For this reason,tighten all connector thumb screws securely. If a USB cable is being used, install the provided USBretention bracket. Insert the USB connector through the square cutout in the base of the bracket and pullthe cable and body of the connector back through the round hole in the bracket flange. Now insert thebracket into the two slots on the rear of the monitor and side it forward so the connector is fully inserted inthe mating bulkhead connector. Install and tighten two 4-40 x .25” Philips screws.NOTE: TO PREVENT INADVERTENT DISCONNECTION OF VIDEO AND/ORSERIAL TOUCHSCREEN CABLES ASSURE THAT THE THUBSCREWS ARESUFFICIENTLY TIGHTENED.WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENTWHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREEOF IGNITABLE CONCENTRATIONS.NOTE: WHEN USING USB TOUCHSCREEN CONNECTION THE USE OF THEUSB RETENTION BRACKET IS REQUIRED FOR HAZARDOUS LOCATIONSAND HIGHLY RECOMMENDED FOR NONHARDAOUS LOCATIONS.WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENTWHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREEOF IGNITABLE CONCENTRATIONS. |
Related manuals for Nematron M1500
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved