Menu
Neilsen CT2217 Instruction & Assembly Manual
            | |
5DO NOT LEAVE THE CART UNATTENDED IN UPRIGHT POSITIONDURING ASSEMBLY.A FALLING CART CANCAUSE PERSONAL INJURY.PAY CLOSE ATTENTION TO THE STABILITY OF THE CART WHILE IT REMAILN IN ANUPRIGHT POSITION.FOR BEST STABILITY,ASSEMBLE ON A SMOOTH,LEVEL SURFACE.ASSEMBLY INSTRUCTIONSIMPORTANT: Due to the weight of the cart, we recommend that you have someoneassist you in lowering the cart onto its wheels after it has been assembled.1. Remove the hardware pack and all loose parts from the carton. Be sure the carton is empty beforediscarding.2. Lay out all the parts and hardware as shown on pages 2 and 3.3. Assemble the cart bed side body and bottom body with Round Head Bolt M6x16, Flat Washer Ø6,Lock Washer Ø6 and Hex Nut M6. See Figure 1.4. Position cart body halves upright on a smooth level surface such as a garage floor or a paveddriveway. See figure 2.5. Assemble halves together using nine Round Head Bolt M6x16, Flat Washer Ø6, Lock Washer Ø6and Hex Nut M6 as shown in Figure 2.Do not tighten at this stage.6. Position the tailgate reinforcement bracket on outside of cart as show in figure 3. Assemble thebottom of the cart body using six Round Head Bolt M8x16, Flat Washer Ø8, Lock Washer Ø8 andHex Nut M8. Do Not tighten. See Figure 3.7. Position the tailgate guides with the holes to the rear as shown in figure 3. Assemble the guides tothe inside of the cart using six Round Head Bolt M6x16, Flat Washer Ø6, Lock Washer Ø6 and HexNut M6. Do Not tighten.8. Assemble two Round Head Bolt M6x16, Flat Washer Ø6, Lock Washer Ø6 and Hex Nut M6 to thetop rear corners of the cart. Do Not tighten. See Figure 3.9. Tighten the six bolts assembled in step 6 and the two bolts in step 8.Tighten the nine boltsassembled in step 5,keeping the bottom of the cart body halves even.10. Lower the cart to rest upside down on tis top flanges. See Figure 4.11. Assembling the wheel support at the rear of the cart using twelve M8X16 round head bolts, FlatWasher Ø8, Lock Washer Ø8 and M8 hex nuts as shown in Figure 4.Bolt heads go on inside of cart.Tighten.CAUTIONFIGURE 1 FIGURE 2 |
Related manuals for Neilsen CT2217
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved