Navitar 368MCZ125 Installation Instructions Manual

Installation of Navitar/ NuView Series 368 lens on EIKI model LC-XT3,XT4, XT9, X5, X4AiL & SX4AiL projectors.TOOLS REQUIRED: PHILLIPS HEAD SCREWDRIVERDisassembly:1. Disconnect unit from power source.2. Remove front cover by removing 2 Phillips screws from bottom of lower cover.Remove 4 remaining Phillips screws from the top cover (2 on top of cover, 2 morenear lower portion of top cover)Assembly:1. Separate your Navitar lens and adapter by gently rotating the lens counterclockwisewhile holding the adapter. DO NOT place undo pressure on the lens to separate asthis may result in damage to the nylon drive pin.2. Insert the keyed portion of the adapter ring into the projector and rotate the lens locklever downward while squeezing together.3. Replace the front cover of the projector removed in step 1, above.4. Reinstall the Navitar lens into the adapter by turning clockwise into the adapter.5. To focus, gently twist the front of the lens. To zoom, loosen thumbscrew and twistthe knurled zoom ring. Re-tighten thumbscrew. CAUTION: When focusing, be surenot to twist lens completely out of the adapter!REV 072005 REP

/ 1

Related manuals for Navitar 368MCZ125