Napoleon GDS50N Operating Instructions Manual

Also see for GDS 50-P: Installation and operation instruction Installation and operation instructions Installation and operating instructions Installation and operating instructions Installation and operating instructions

Napoleon GDS50N Operating Instructions Manual Manual pdf 25 page image

25W415-0098 / H / 03.19.124.3 B-VENT INSTALLATION - GS504.3.1 CHIMNEY INSTALLATION4.3.2 INSTALLING FLASHING AND STORM COLLAR63.7A“A” VENT - SOLIDFUEL WOOD BURNINGCHIMNEY & VENTCONNECTOR(LINER NEEDEDIF INSIDEDIAMETER IS 6”OR LARGER)SINGLE WALLOR “B” VENTMASONRY CLAY LINEDCHIMNEY + VENTCONNECTOR(NO NEW LINERNEEDED IF OLDLINER DIAMETERIS 4-5”)SINGLE WALLOR “B” VENT“B” VENTLIQUID FUELGAS BURNINGCHIMNEYA CHIMNEY VENTING THIS APPLIANCE SHALL NOT VENT ANY SOLID FUEL BURNING APPLIANCE.! WARNINGA chimney venting this appliance shall not vent any solid fuel burning appliance.All horizontal runs must have a 1/4" rise per footThree types of chimney systems may be used with this appliance.88.1Remove the nails from the shingles above and to the sides ofthe chimney. Place the flashing over the chimney pipe and slideunderneath the sides and upper edge of the shingles. Ensure that thechimney pipe is properly centered within the flashing, giving a 3/4”margin all around. Fasten to the roof on the top and sides. DO NOTNAIL through the lower portion of the flashing. Make weather-tightby sealing with caulking. Where possible, cover the sides and topedges of the flashing with roofing material. Apply waterproof caulking,provided with the flashing, around the chimney, 1” above the top ofthe flashing and push the storm collar down into the caulking. Insert arain cap onto the top of the last chimney section.RAIN CAPCAULKINGSTORM COLLARWEATHERSEALANTFLASHING