Nakanishi NR33-6000ATC-ESD Operation Manual

Nakanishi NR33-6000ATC-ESD Operation Manual Manual pdf 1 page image

1OPERATION MANUALNR33 - 6000ATC - ESDAutomatic Tool Replacement SpindleThank you for purchasing the Automatic Tool Replacement Spindle " NR33-6000ATC-ESD ". This Spindle isdesigned for cutting and separating PCB. The E3000 CONTROLLER, Brushless Motor and Air Line Kit are requiredto drive this Spindle. Read this and all the associated component Operation Manuals carefully before use. Alwayskeep this Operation Manual in a place where a user can referred to for reference at any time.0001 . CAUTIONS FOR HANDLING AND OPERATIONRead these warnings and cautions carefully and only use in the manner intended.These warnings and cautions are intended to avoid potential hazards that could result in personal injury to theoperator or damage to the device. These are classified as follows in accordance with the seriousness of the risk.Class Degree of RiskWARNING A safety hazard could result in bodily injury or damage to the device ifthe safety instructions are not properly followed.CAUTION A hazard that could result in light or moderate bodily injury or damageto the device if the safety instructions are not followed.WARNINGThis Spindle is not a hand tool. It is designed to be used on CNC machines or special purposemachines.Do not touch the cutting tool while it is running. It is very dangerous.Wear safety glasses, dust mask, and use a protective cover around the Spindle whenever theSpindle is rotating.Never connect, disconnect or touch the Power Cord Plug or Motor Cord Plug with wet hands.This may cause an electric shock.Never operate or handle the brushless motor and Spindle until you have thoroughly read theOperation Manuals and safe operation has been confirmed.1) To prevent injuries / damages, check the Spindle, brushless motor and cutting tool forproper installation, before operating the Spindle and brushless motor.2) Before disconnecting the Spindle and brushless motor, always turn the control power offand turn the compressed air supply to the CONTROLLER off. Then it is safe to remove theSpindle and brushless motor.Whenever installing a Spindle to a fixed metal base, ensure that the fixed metal base isgrounded in order to avoid risk of an electric shock.When installing a tool, tighten the collet correctly and check again the collet before use. Do notover-tighten the collet. This may cause damage to the Spindle.Do not open and close the collet while the brushless motor is runing.Do not use bent, broken, chipped, out of round or sub-standard tools, as this may cause themto shatter or explode. Tools with fractures or a bent shank will cause injury to the operator.When using a new tool, rotate it in a low speed and increase speed gradually for safety.Do not exceed the recommended maximum allowable speed of the tool. For your safety, usespeeds below the maximum allowable speed.Do not apply excessive force. This may cause injury to the operator by slippage or damage ofthe tool, or loss of concentricity and precision of the Motor Spindle.OM-KK0912EN