14Washing programmes** depends on the modelSensitiveFor washing fabrics with increased hygiene requirements or those that willbe used by allergy sufferers. The temperature remains constant during thewashing process. More intensive rinsing with increased water level. Forhard-wearing and easy-care fabrics made from cotton or linen.Night WashParticularly quiet wash programme with a reduced final spin.Sleep mode. Once the programme has finished, the display goes out, butcan be reactivated by pressing any button.Drying programmes Intensive DryIntensive drying for a (robust fabrics), at 90°C.Gentle DryGentle drying for ` (easy-care fabrics), 60°C.Special programmes Fluff CleanThe drum must be empty.This programme is designed to clean the drying cycle of any fluffdeposits. The washer-dryer uses the flashing symbol l (Fluff removalcycle) in the display panel to show that this programme must be run. Theelectronic cycle counter is then automatically reset. Thel (Fluff Clean) symbol goes out after the programme starts.To run the Fluff Clean, proceed as follows: Make sure that the drum is completely empty and close the door. Turn the programme selector to Fluff Clean. Press the Start/Pause button.The Fluff Clean programme can also be run at any time withoutprompting by the appliance.Rinse + Spin:An additional rinse cycle with a final spin. If the laundry is to be removeddripping wet, set the Spin speed to $ (Rinse hold) before Programmestart –> page 15.Drain + Spin :Drain the rinsing water following a programme with$ (Rinse hold) –> page 15. Turn the programme selector to Drain + Spin. Set the spin speed to $ (Rinse hold). Press the Start/Pause button.orDrain and spin at the desired spin speed: Turn the programme selector to Drain + Spin. Press the Spin button repeatedly until the desired spin speed is set. Press the Start/Pause button.ii