253. Projecting an Image (Basic Operation) Selecting a SourceSelecting the computer or video sourceVIDEO S-VIDEO COMPUTER-1 COMPUTER-2LAMPSTATUSPOWERAUTOADJ.ON/STAND BYSELECTVOLUMEL-CLICKMOUSER-CLICKAUTO ADJ.ASPECT HELPFREEZEPICTURES-VIDEOVIDEO COMPUTER12NOTE: Turn on the computer or VCR connected to the projector.Using the cabinet buttonsPress any one of the COMPUTER 1/2 (COMPUTER button on VT47),VIDEO and S-VIDEO buttons.The corresponding indicator will light green.Using the Remote Control (VT670/VT470)Press any one of the COMPUTER 1/2, COMPONENT, VIDEO or S-VIDEO buttons.Selecting from the Source List (VT570/VT47)1. Press and quickly release the SOURCE button on the remotecontrol.The Source list will be displayed. SOURCE PIC-MUTEPOWERASPECT2. Press and quickly release the SOURCE button to select thesource in the Source list.Each time the SOURCE button is pressed, the selection in theSource list will change as follows:VT570Computer 1 → Computer 2 → Video → S-Video → Computer 1 → ...VT47Computer → Video → S-Video → Computer → ...3. Press the ENTER button to display the selected source.NOTE: Highlighting the source for 2 seconds without pressing the ENTERbutton will also display the selected source. SOURCE PIC-MUTEPOWERASPECTVT670/VT470VT570/VT47VT570 VT47VT570/VT47
