NEC UNIVERGE DT830G(DG) User Manual

Also see for DT830 Series: Quick reference card Quick reference guide User guide User guide Quick reference card

Contents

NEC UNIVERGE DT830G(DG) User Manual Manual pdf 101 page image

CID (CALLER ID) CALLDISPLAYWithout answering incoming calls or held calls thatterminate to the Line keys of a terminal, the callingparty’s information can be confirmed by theindications on the LCD.The feature key is set by system data settingat initial installation. For details, pleasecontact the system administrator.TO DISPLAY CALLING PARTYINFORMATION1. Press CID Call Display feature key.Line key lamp lights red. →Calling Party information is displayed.201JAMES SMITHR-TONE MICTO REDISPLAY CALLINGPARTY INFORMATION1. While on a call press CID CallDisplay feature key to recall theCalling Party Information.Calling Party information is displayed.VOICE FIRST/TONE FIRSTThis feature allows incoming calls to your terminalto either ring or go to voice announcement.The feature access code/feature key is set bysystem data setting at initial installation. Fordetails, please contact the systemadministrator.TO SET VOICE FIRST/TONEFIRST MODE1. Press Speaker key.You will receive a dial tone.Speaker key lamp lights red. →2. Dial Voice First/Tone First accesscode or press Voice First/Tone Firstfeature key.LCD shows current mode.You will receive a feature dial tone.VOICE11:00 AM SUN 1 JUN 2014Recall PICK >>>>3. Dial any single digit ( - ).Voice First mode is switched to Tone Firstmode (or vice versa).You will receive a feature set tone.TONE11:00 AM SUN 1 JUN 2014Recall PICK >>>>4. Press Speaker key.Speaker key lamp goes off. →5. The called party can reply.FEATURE OPERATION94