674. Using On-Screen Menu[OPTIONS(2)]Selecting Power-saving in [STANDBY MODE]The projector has two standby modes: [NORMAL] and [NETWORK STANDBY].The NORMAL mode is the mode that allows you to put the projector in the power-saving condition which consumesless power than the NETWORK STANDBY mode.NORMAL�����������������������������POWER indicator: Red light/STATUS indicator: OffWhen [NORMAL] is selected, only the following buttons and feature will work:POWER button on the projector cabinet and the remote control, powering on from PC Controlcommand, and AUTO POWER ON�NETWORK STANDBY ����������POWER indicator: Orange light/STATUS indicator: OffWhen [NETWORK STANDBY] is selected, the projector can be turned on over a wired LAN connec-tion and only the following buttons, port, and features will work:POWER button on the projector cabinet and the remote control, powering on from PC Controlcommand, AUTO POWER ON, Operation by User Supportware, Network service, Program Timer�Important:• In the below conditions, setting of the [STANDBY MODE] is disabled and the projector will go into the SLEEP mode*.* Sleep mode refers the mode without functional restrictions by the [STANDBY MODE]. Power consumption in the SLEEP modeis relatively higher than the [NETWORK STANDBY] mode. The Status indicator turns on in Green.When [STANDBY MODE] → [NETWORK STANDBY] is selected- When [NETWORK SERVICE] → [AMX SETTINGS] → [ENABLE] is selected- When [NETWORK SERVICE] → [CRESTRON SETTINGS] → [CRESTRON CONTROL] → [ENABLE] is selected- When [NETWORK SETTINGS] → [WIRELESS LAN] → Except for [DISABLE] and mounting the wireless LAN unit to the projector- When the signal is input to the computer, HDMI1/MHL or HDMI2 terminalsRegardless of the [STANDBY MODE]- When the USB cable is connected to the projector and the computerNOTE:• Even when [NORMAL] is selected for [STANDBY MODE], power on or off can be done by using the PC CONTROL port.• The power consumption in the standby mode will not be included in calculating CO2 emission reduction.• Your setting will not be affected even when [RESET] is done from the menu.Enabling Direct Power On [DIRECT POWER ON]Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates theneed to always use the POWER button on the remote control or projector cabinet.
