NEC SigmaBlade N8406-022 User Manual

Contents

NEC SigmaBlade N8406-022 User Manual Manual pdf 56 page image

(English)34ConfigurationThe Switch Module can be configured locally using the Serial Port or remotely using the Ethernet ports.Connection via Serial PortUse a serial cable (with a female DB-9 connector) to connect between a management console (such as a personalcomputer) and the Serial Port. A communication software conformed to VT100 terminal emulation is required. Setthe parameters of communication software as shown in the table below.Baud rate 9600Data bits 8Parity NoneStop bits 1Flow control NoneIMPORTANT: A leased line cannot be connected to the Serial Portdirectly.NOTES:・ The command line interface has 2 modes, AOS CLI and ISCLI. Youcan set the Switch Module to use either CLI mode. By default, themode is AOS CLI.・ When operating the Switch Module with NEC WebSAMNetvisorPRO, use ISCLI.Connection via NetworkTo connect to this Switch Module via network, you need to assign an IP address to it. You can access thebrowser-based interface or the command line interface in the switch througn a telnet application or Web browserby using the assigned IP address.IP address is configured by the following.- Assignment by DHCP (by default)- Manual assignment- Assignment by DHCPBy default, the management network interface on the Switch Module is set up to obtain its IP address from theDHCP server on the Enclosure Manager Card. You can configure the IP address in the Enclosure ManagerCard. For more information, see the Enclosure Manager Card User’s Guide.NOTES:・ If the IP address cannot be obtained from the DHCP server, accessthe local console of the Switch Module and assign the IP addressmanually. Refer to “Manual assignment” below. After assigning the IPaddress, then access the Switch Module via network.・ Port 19 of the Switch Module is connected with the managementnetwork in the Blade Enclosure.・ Refer to the Blade Enclosure User’s Guide and the EnclosureManager Card User’s Guide about how to connect or configure theEnclosure Management LAN port.