NEC SX10000 User Manual

Also see for Nighthawk SX10000D: Brochure Installation data

Contents

NEC SX10000 User Manual Manual pdf 43 page image

E – 36Lamp ModeThis feature allows the lamp power supply to operate under three set-tings.Maximum ..... This setting consumes maximum current from the AC inputand results in the most light output.NOTE: The Maximum mode shortens the lamp life. Be sure to use this modeat temperature of 95˚ F (35˚C) or less.Medium ....... This setting allows the lamp power supply to draw a mediumamount of current from the AC input source and allows formedium power consumption.Minimum ..... This setting consumes minimum current from the AC inputand results in the least light output.LampReturns all adjustments and settings to the factory preset level.All Data ....................... Reset all the settings for all the signals to the factorypreset.NOTE: The items that can be reset are all the settings and adjusts except forLanguage, Projector ID, Lamp Hour Meter, Projector Usage and Communi-cation Speed.Including Entry ListAlso deletes all the signals in the Entry List and re-turns to the factory preset.Current Signal ............. Resets the adjustments for the current signal to thefactory preset levels.NOTE: All the items in "Adjust (Source)" can be reset.Projector OptionsEnables you to set preferences and other operating options.TimerEnables you to turn on or off your projector automatically at a specifiedtime. Two timer functions are available: On/Off Timer and Sleep Timer.On/Off TimerUp to eight settings can be programmed.• Before setting On/Off Timer, make sure that Date, Time Preset feature isset.• Even after setting On/Off Timer, turning the projector on or off with theremote control is possible.• There are two time display formats: 24-hour or AM/PM format.1. Open the On/Off Timer window.2. Select EDIT and press ENTER on the remote control to open the EDITwindow.3. Set the Week, Day, On-Time and Off-Time using the Select buttons andSource buttons (1 thru 10). To cancel the on-time or off time, use Delete.4. Select Set and press the ENTER button on the remote control to completethe setting. To close, select Close.Reference White BalanceThis feature adjusts the white balance that is used as a reference.This adjustment affects all sources. The Ref.White Bal. is availablefor test pattern only.Factory Default