CHAPTER 3 ND-45895 (E)Page 20Revision 1.0INSTALLATIONSTEP 2: Mount the PN-AP00 card in any one of the AP slots in PIM0 – PIM7.After mounting, set the SENSE switch to an unequipped slot number inCM05;Set the MB switch to the down position to put the card in service. For de-tails on mounting location, refer to the Circuit Card Manual.Figure 3-5 Mounting Location of the PN-AP00 CardATTENTIONContentsStatic SensitiveHandlingPrecautions Required• MOUNT THE PN-AP00 CARD IN ANY ONE OF THE AP SLOTS (AP0 – AP8).• SET THE SENSE SWITCH OF PN-AP00 CARD TO AN UNEQUIPPED SLOT NUMBER TO WATCH CM05 AS SHOWN BELOW.SLOT NUMBER 04 05 06 07 08 09 10 11 12 13 14 15SWITCH SETTING VALUE 4 5 6 7 8 9 A B C D E FBUS/AP8MP/FP/AP7AP6LT15/AP5LT14/AP4LT13/AP3LT12/AP2LT11/AP1LT10/AP0LT09LT08LT07LT06LT05LT04LT03LT02LT01LT00BUILT-IN BATTERYPWRPIM 0 ~ 7PN-AP00
