NEC NP600CM Installation And Assembly Manual

Also see for NP300 XGA: Control commands Technical data sheet Installation and assembly Installation and assembly Installation guide

Contents

NEC NP600CM Installation And Assembly Manual Manual pdf 10 page image

ISSUED: 08-05-08 SHEET #: 056-9008-1Visit the Peerless Web Site at www.peerlessmounts.com10 of 10For customer care call 1-800-865-2112 or 708-865-8870.SCREW FOR YAW (SWIVEL) STOP(REFER TO STEP 2, INSTALLATIONTO EXTENSION COLUMNS, FIG. 2.3)KNOB FOR ROLLADJUSTMENTKNOB FOR PITCHADJUSTMENTBACK OF MOUNTACCESS SLOT FOROPEN END WRENCHALLOWS TIGHTENINGOF WOOD SCREW (F)WITHOUT REMOVINGPROJECTORARROW INDICATESFRONT OF MOUNTTo adjust yaw (swivel) for wood stud, concrete ceiling, and threaded rod mounting applications:Loosen wood screws (F) if flush mounted to wood joists (page 5) or concrete ceilings (page 6), or loosenlocknuts on threaded rods (page 7), until projector mount can be rotated. Rotate mount to desired position andretighten screws or locknuts.To adjust yaw (swivel) for extension column applications: Loosen screw on projector mount assembly (A)indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out andturn by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by handfor easy adjustment or insert #2 phillips screwdriver in end of knob and turn.ATo prevent tampering with the pitch and roll adjustments: Tighten the two tamper resistant security screwson the projector mount assembly using 4 mm security allen wrench (B) to lock the pitch and roll adjustments asshown below.Note: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly ordamage may occur.CAUTIONSIDE VIEWProjector Alignment77-1TO LOCK PITCH TIGHTENTAMPER RESISTANTSECURITY SCREW© 2008, Peerless Industries, Inc. All rights reserved.All other brand and product names are trademarks or registered trademarks of their respective owners.

/ 10

Related manuals for NEC NP300 XGA