393. Projecting an Image (Basic Operation) After UsePreparation: Make sure that the projector is turned off.1. Unplug the power cable.2. Disconnect any other cables.3. Retract adjustable tilt foot if extended.4. Cover the lens with the lens cap.5. Put the projector and accessories in the supplied soft case.Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens fromdamage.NOTE: The NP610S, the NP510WS, the NP405, and the NP305 do not come with a soft case.NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to theprojector.CAUTION:Use caution when putting the projector in the soft case immediately after the projector has been operating. Theprojector cabinet is hot.Insert the projector with the lensfacing upward
