NEC MultiSync X401S User Manual

Also see for MultiSync X461S: Specifications Control guide Manual Manual Specifications

NEC MultiSync X401S User Manual Manual pdf 27 page image

English-25EnglishINFORMATION OSD Selects whether the information OSD is displayed or not. The information OSD will be displayedwhen the input signal or source changes. The information OSD will also give a warning whenthere is no-signal or the signal is out-of range.An interval between 3 to 10 seconds for the Information OSD to appear is available.ON, 3 Sec.MONITOR INFORMATION Indicates the model and serial number of your monitor.CARBON SAVINGS: Display the estimated carbon saving information in kg-CO2. The carbonfootprint factor in the carbon saving calculation is based on the OECD (2008 Edition).CARBON USAGE: Display the estimated carbon usage information in kg-CO2. This is thearithmetic estimation, not actual measurement value. This estimation is based without anyoptions.-OSD TRANSPARENCY Set the transparency of the OSD. ONOSD ROTATION Determines the OSD display direction between landscape and portrait. LANDSCAPELANDSCAPE Display the OSD with landscape mode.PORTRAIT Display the OSD with portrait mode.INPUT NAME You can create a name for the INPUT currently being used.Max: 8 characters, including Space, A-Z, 0-9, and some symbols.-CLOSED CAPTIONVIDEO1, VIDEO2, S-VIDEO inputs onlyActivates closed captioning. OFFRESET Resets the following settings within the OSD menu back to factory setting:MENU DISPLAY TIME, OSD POSITION, INFORMATION OSD, OSD TRANSPARENCY,CLOSED CAPTION.-MULTI DISPLAYCONTROL ID Sets the monitor ID number from 1-100 and group ID from A-J. When “YES” is selected in“AUTO ID”, monitor ID numbers are set automatically in all monitors which follow in the chain withRS-232C.NOTE: Group ID is made of multiple selections.1IR CONTROL Selects the mode of the monitor for use with the infra-red remote control when using theRS-232C daisy chain.NORMALNORMAL The monitor will be controlled normally using the remote controller.PRIMARY Choose “PRIMARY” for the fi rst monitor within an RS-232C daisy chain.SECONDARY Choose “SECONDARY” for all subsequent monitors within an RS-232C daisy chain.LOCK Prevents the monitor from being controlled by the wireless remote controller. To return to normaloperation, press the “DISPLAY” button on the remote controller for 5 seconds.TILE MATRIX Allows one image to be expanded and displayed over multiple screens (up to 100) through adistribution amplifi er.NOTE: Low resolution is not suitable for tiling to a large number of monitors. You can operatewithout a distribution amplifi er at a lower number of screens.H MONITORS Number of monitors arranged horizontally. 1V MONITORS Number of monitors arranged vertically. 1POSITION Select which section of the tiled image to be displayed on the monitor. 1TILE COMP Turns the TILE COMP feature on. NOENABLE Enables Tile Matrix. NOTILE MATRIX MEM When “INPUT” is selected, TILE MATRIX setting is applied to each signal input. COMMONPOWER ON DELAY Adjusts the delay time between being in “standby” mode and entering “power on” mode.“POWER ON DELAY” can be set between 0 and 50 seconds.0 Sec.POWER INDICATOR Turns ON or OFF the LED located at the front of the monitor.If “OFF” is selected, LED will not light when the LCD monitor is in active mode.ONEXTERNAL CONTROLCONTROL Selects the control interface, RS-232C or LAN. RS-232CLAN RESET Resets the LAN settings. -ID=ALL REPLY When controlling the monitor externally, select if the communication command, which specifi esdestination equipment ID (ALL or GROUP ID), is replying or not. When you need reply, pleaseselect “ON”.If you connect the multiple monitors that are daisy-chained from second monitor by RS-232C,you need to select “OFF” from second monitor.OFFMAC ADDRESS Displays the MAC ADDRESS. -