NEC LCD1511M Service Manual

NEC LCD1511M Service Manual Manual pdf 12 page image

To set up this display, please refer to the following figure and procedures.1. Make sure that the entire equipment is turned off.2. Connect one end of the power adapter to the power connector; plug one endof the AC power cord into the power adapter, and then the other end into anelectrical outlet (1).3. Connect the VGA signal cable to the 15-pin connector of your host computerand tighten the screws (2).4. Connect the Audio-In cable from audio input port of your display to the Audio-out port of your computer (3).5. Connect your headphone to the Headphone port (4).6. Turn on your computer and display.Notice: To ensure the LCD display can work well with your computer, pleaseconfigure the display mode of your graphic card to make it less than orequal to 1024 x 768 resolution and make sure timing of the display modeis compatible with the LCD display.We have listed the "Compatibility Modes" of this LCD display in appendi-ces for your reference.Figure 8.1Connecting the Display (Figure 8.1)(1) Power Adapter& Power Cord(2) VGA Cable(4)Headphone(optional)(3) Audio-IncableLCD1511M – 8English