NEC HT1000 User Manual

Also see for HT1000 Series: Control commands Command guide Command guide Control commands Compatibility chart

Contents

NEC HT1000 User Manual Manual pdf 19 page image

E-19Press and hold the SOURCE button for a minimum of 1 second, theprojector will search for the next available input source. Each time youpress and hold the SOURCE button, the input source will change asfollows:→ Video → S-Video → Component → RGB → DVI(DIGITAL) → Viewer If no input signal is present, the input will be skipped. When the inputsource you wish to project is displayed, release the button.Press the ENTER button.Selecting a SourceSelecting the computer or video sourceUsing the Remote ControlASPECTOFFVIDEOAUTO ADJ.ON3D REFORMMAGNIFYPIC-MUTEVIEWERSLIDEFOLDERSLIDELISTPOWERFREEZES-VIDEO COMPONENT RGBDVIEFFECTOR PICTUREPOSITIONHELP VOLUMEPress any one of the VIDEO, S-VIDEO, COM-PONENT, RGB, DVI or VIEWER buttons.Source ListNOTE: If no input signal is available, the projector will display a blue background(factory preset).Selecting from Source ListPress and quickly release the SOURCE button on the projector cabinetto display the Source list. Each time the SOURCE button is pressed, theinput source will change as follows: "Video" (VCR, or laser disc player),S-Video", "Component" (DVD player), "RGB" or "DVI(DIGITAL)" (com-puter) or "Viewer" (slides on a PC card).To display the selected source, press the ENTER button.Detecting the Signal AutomaticallyAdjusting the Picture Size and PositionPlace your projector on a flat level surface and ensure that the projectoris square to the screen.Lift the front edge of the projector to center the image vertically.Move the projector left to center the image horizontally on the screen.* If the projected image does not appear square to the screen thenuse the 3D Reform feature for proper adjustment. See page E-20.Adjust the Tilt Foot1. Lift the front edge of the projector.SELECTCNACELTERNEEMNUSOURCEAUTO ADJUSTON STAND BYSTATUSPOWERLAMPALIGNMENTPC-CARDAdjustable Tilt Foot LeverAdjustable Tilt FootSELECTCACELTERNEEMNUSOURCEAPC-CARD2. Push up the Adjustable Tilt Foot Lever on the front of the projector toextend the adjustable tilt foot (maximum height).3. Push down the Adjustable Tilt Foot Lever.4. Lower the front of the projector to the desired height and release theAdjustable Tilt Foot Lever to lock the Adjustable tilt foot. There is ap-proximately 7 degrees of up and down adjustment for the front of theprojector.Adjusting Screen PositionSee "Selecting Aspect Ratio and Position for Screen" on page E-43.