4-64 Disassembly and Reassembly10. Snap the replacement I/O shield into place in the rear panel.11. Install the system board following procedures previously described in thischapter.12. Install the left-hand side access panel.LED/Switch AssemblyYour server system contains a front panel that houses the LED/switch assembly.You must open the front bezel to access the front panel. To remove the frontpanel LED/switch assembly, perform the following procedures:1. Prepare your system for disassembly. See Preparing Your System forDisassembly and Reassembly earlier in this chapter.2. Remove the left-hand side access panel of the system chassis followingprocedures previously described in this chapter.3. Remove the front panel following procedures previously described in thischapter. See Front Panel earlier in this chapter.4. Remove the power switch, reset switch and dump switch from the front ofthe chassis. To release these switches, squeeze their two plastic snap tabstogether and slide the switch back until it is free of the chassis.See Figure 4-59, A.ABCA Switches (3)B CableC System Board ConnectorFigure 4-59. Replacing the LED/Switch Assembly
