OneStart

Menu

NEC EU1V0UM00 Quick Start Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Contents
  1. Table Of Contents
  2. Introduction
  3. Hardware Setup
  4. Standalone Operation
  5. Software Setup
  6. Using the NEC Electronics C Compiler and Source Code Debugger
  7. Download and Debug the Code
  8. GUI Operation
NEC EU1V0UM00 Quick Start Manual Manual pdf 16 page image
Motor Control I/O Board User’s ManualFigure 12. PM Plus Workspace4. Click File and select Open Workspace.5. Browse to C:\NECTools32\ \Motor_Control\BLDC_Hall_714 and select BLDC_LV.prw PMPlus workspace file.6. The newly loaded workspace file will contain one project called LV_BLDC_Hall-714.prj asshown below.Figure 13. PM Plus Window7. To recompile the code, click Build and select Rebuild.8. At this point, you may change the code and recompile as needed.9. After building the code successfully, you may download and run or debug the code using an on-chip debugging emulator.9. Download and Debug the Code1. To debug the code, select Debug from Build menu or click the Debug button on the tool bar. Bydefault the code automatically will be downloaded to the microcontroller’s flash memory10
/ 19
Related manuals for NEC EU1V0UM00
NEC N8151-69 Startup Manual first page preview
NEC N8151-69 Startup Manual
NEC 92001 Installation Instructions Manual first page preview
NEC 92001 Installation Instructions Manual
NEC Consolidated Power Supply Unit Configuration Manual first page preview
NEC Consolidated Power Supply Unit Configuration Manual
This manual is suitable for:
EU1V0UM00MC-LVKIT-714
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved