Menu
NAVIS WS 010-2 Manual
Also see for WS 010-2: Manual
  |
WIRELESS WIND SPEED/DIRECTION SENSORMANUALModels: WS 010-2, WSD 011-2OPERATINGSensors continuously measure and transmit data of wind speed, wind direction and air temperature.Data packets are transmitted every two second. On display units you can read data of current, average andmaximum wind speed, wind direction, temperature or view history graphs.SENSOR ADDRESSThe sensor address is indicated on the label attached to the sensor and in the interior of its battery compartment.RANGEThe connection between the sensor and the receiving unit works on free 902-928 MHz band. The operating rangeis up to 500 meters (1300 meters at “X” models) - at 10 m sensor mounting height and when there is no obstaclebetween the sensor and the display unit. The range inside buildings is considerably shorter as the signal can benormally received through two to three walls.BATTERY REPLACEMENTWS 010-2 SENSOR:Take off the battery cover by turning sensors bottom part anticlockwise. Pull out the battery holder and insert newbattery (3,6V AA Lithium battery).WSD 011-2 SENSOR:Loosen and remove the locking screw on battery compartment (horizontal cylinder) and pull out the plug. Pull outthe battery holder and insert new battery (Lithium 3,6 V AA). Return the plug and secure it with screw.FCC INSTRUCTION TO THE USERIMPORTATN! Changes or modifications not expressly approved by the party responsible for compliancecould void the user’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.FCC ID: 2AK8G-NAVIS-WS01NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuantto part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses and can radi-ate radio frequency energyand, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/ TV technician for help. |
Related manuals for NAVIS WS 010-2
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved