Menu
NARGESA MC650 Instruction Book
Also see for MC650: Instruction bookInstruction book
                                               | |
Contents
| 
MC650 SECTION BENDING MACHINE INSTRUCTION BOOK 135. INSTRUCTIONS FOR USE5.1. Bending principles- The motor of the bending machine is controlled from the control panel.- The radius of the curve is controlled by acting on the push buttons on the control panel, adjusting theheight of the two lower rollers.- There is an emergency button on the panel.- You can insert the material into the machine from either side. Use the position buttons to adjust the heightof the lower rollers and thus adjust admission of the material. By means of the limit switches, we can posi-tion the final point of the lower rollers, separately, enabling you to obtain great position repeatability.- To adjust the alignment of the material, it is necessary to modify the distance between the straighteners andthe work surface. This is done by acting on the nuts located at the back of the machine. These straightenersguide the material so as to minimise lateral deformation. (The rollers of the straightener must press gentlyagainst the section to be curved)- In the event of not obtaining the proper results, the position of the guide rollers for deformation must beadjusted.- The roller mounting nuts must be tightened by manual force only .5.2. Assembly of the rollersFigure 10. Position of the rollers in relation to the machine axes |
Related manuals for NARGESA MC650
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved