NAPCO Gemini GEM-X255 Operating Manual

Also see for Gemini GEM-X255: Installation instructions Installation instructions Installation instructions Programming instructions

Contents

NAPCO Gemini GEM-X255 Operating Manual Manual pdf 23 page image

23P R O G R A M M I N G ( O P T I O N A L )Reviewing a Programmed User CodeTo review an existing User Code, enter the 2-digit user number and the corresponding User Code will display.Exiting the User Program ModeWhen you have completed programming or erasing User Codes, press C to exit the User Program Mode.Programming ExampleProgram the User 30 Code to ì3784î:1 Enter your User Code, followed by A.2 Answer NO (press F ) repeatedly until ìACTIVATE PROGRAM Y/Nî is displayed, then press YES (E).• The display will read ìENTER USER CODEî3 Press 030 for User No. 30, then press A, A, followed by 3784.4 Press Jto save the code.5 Press C to exit the Program Mode.Notes:• If the system contains more than one keypad, only the keypad designated ìNo. 1î may be used for programming (if indoubt which is No. 1, ask your installer).• While in Program Mode, the ARMED and STATUS lights remain off and burglar and fire alarm functions are disabled.• In selecting your codes, do not program repetitive numbers (1111), consecutive numbers (1234), your birth date, address,or other obvious combinations. Choose a code of up to six digits (a minimum of four is recommended, and required in ULinstallations).If the keypad detects no Program Mode activity for more than 4 minutes, a tone will sound. Press C tosilence.