NAPCO Gemini GEM-P1632 Installation Instructions Manual

Also see for Gemini GEM-P1632: Installation instructions Programming instructions Installation instructions Installation instructions Installation instructions

NAPCO Gemini GEM-P1632 Installation Instructions Manual Manual pdf 49 page image

L NAPCO Security Systems X GEM-P1632 Installation InstructionsWI808F 8/03 !Page 49Keypad Programming Modes: Keypad Configuration ModeKEYPAD CONFIGURATION MODEGEM-RP1CA/1CAe/1CAe2/GEM-K1CA KEYPADSPress R (or A) buttonEnter Factory Code:11123Configure:• Keypad Beep ON/OFF• Entry Sounder• Keypad Address 01• New Compat# 000 **Press Cbutton(ì01 OUT OF SYSTEMî)Return Jumper JP1 * from Pins 2-3 to Pins 1-2(ìSYSTEM READYî)Move Jumper JP1 * from Pins 1-2 to Pins 2-3(Wait about 15 seconds: ìOUT OF SYSTEMî)Configure:• Keypad Address (Jumpers J1-J3)• Touchpad Backlight (Jumper A)• LCD Backlight (Jumper B)GEM-RP2AS/RP2ASe/RP2ASe2KEYPADS* JP1 is located at the top center of the circuit board.** Not available in the GEM-P1632.1 2435 67 8 9 0ABCD EFGNEXT/YESPRIOR/NOAREAScroll DownScroll UpExitYesNoFor "Classic" Keypads1 2435 67 8 9 0ABCD EFGNEXT/YESPRIOR/NOAREAScroll DownScroll UpExitYesNoRFor "K Series" Keypads