NAPCO GEM-RP2ASe2 Operating Manual

Also see for Gemini GEM-RP2ASe2: Installation instructions Programming instructions Installation instructions Installation instructions Operating guide

Contents

NAPCO GEM-RP2ASe2 Operating Manual Manual pdf 28 page image

28K E Y P AD M E S S AG E SThe keypad can display the following functional messages. Many are two-line messages; hold down G to display the secondline. (In this booklet, both are shown simultaneously for convenience). Other diagnostic messages are available for the installer orservicer. Should any unfamiliar messages appear, call your dealer for service.All zones operating; system can be armed. If displayed, a number following the “READY”display denotes the area number. A "MONITOR ON" display indicates that Chime orWatch Mode is on. Note: If Watch Mode is programmed, “MONITOR ON” will not dis-play for Chime Mode.Panel reporting to central station on arming. If necessary, wait for ringback signal beforeexiting.Exit delay in progress. XX denotes exit time remaining. If displayed, BYPASSED indicatesarming with zones bypassed; INSTANT ON indicates arming with Instant protection.Entry delay in progress. XXX shows entry time remaining.Panel armed. If displayed, a number following the ARMED display denotes the area num-ber.Zone(s) not secured (doors or windows may be open). Faulted zone(s) will scroll.A C O NREADYA C O NWAITA C O NEXITXXA C O NFAULTA C O NARMED1A C O NDISARMXXXSEC