NAD T760 Owner's Manual

Also see for T760: Specifications Service manual

Contents

NAD T760 Owner's Manual Manual pdf 2 page image

NAD2Warning: To reduce the risk of fire or electric shock, do not expose thisunit to rain or moisture.The lightning flash with an arrowhead symbol within an equilateral trian-gle is intended to alert the user to the presence of uninsulated “danger-ous voltage” within the product’s enclosure that may be of sufficientmagnitude to constitute a risk of electric shock to persons.The exclamation point within an equilateral triangle is intended to alertthe user to the presence of important operating and maintenance(servicing) instructions in the literature accompanying the product.Do not place this unit on an unstable cart, stand or tripod,bracket or table. The unit may fall, causing serious injury to achild or adult and serious damage to the unit. Use only with acart, stand, tripod, bracket or table recommended by the man-ufacturer or sold with the unit. Any mounting of the device on awall or ceiling should follow the manufacturer’s instructionsand should use a mounting accessory recommended by themanufacturer.An appliance and cart combination should be moved with care. Quick stops,excessive force and uneven surfaces may cause the appliance and cart combi-nation to overturn.Read and follow all the safety and operating instructions before connecting orusing this unit. Retain this notice and the owner’s manual for future reference.All warnings on the unit and in it’s operating instructions should be adhered to.Do not use this unit near water; for example, near a bath tub, washbowl, kitchensink, laundry tub, in a wet basement or near a swimming pool.The unit should be installed so that its location or position does not interfere withits proper ventilation. For example, it should not be situated on a bed, sofa, rugor similar surface that may block the ventilation openings; or placed in a built-ininstallation, such as a bookcase or cabinet, that may impede the flow of airthrough its ventilation openings.The unit should be situated from heat sources such as radiators, heat registers,stoves or other devices (including amplifiers) that produce heat.The unit should be connected to a power supply outlet only of the voltage andfrequency marked on its rear panel.The power supply cord should be routed so that it is not likely to be walked on orpinched, especially near the plug, convenience receptacles, or where the cordexits from the unit.Unplug the unit from the wall outlet before cleaning. Never use benzine, thinneror other solvents for cleaning. Use only a soft damp cloth.The power supply cord of the unit should be unplugged from the wall outlet whenit is to be unused for a long period of time.Care should be taken so that objects do not fall, and liquids are not spilled intothe enclosure through any openings.This unit should be serviced by qualified service personnel when:A. The power cord or the plug has been damaged; orB. Objects have fallen, or liquid has been spilled into the unit; orC. The unit has been exposed to rain or liquids of any kind; orD. The unit does not appear to operate normally or exhibits a marked change inperformance; orE. The device has been dropped or the enclosure damaged.DO NOT ATTEMPT SERVICING OF THIS UNIT YOURSELF.REFER SERVICING TO QUALIFIED SERVICEPERSONNEL.Upon completion of any servicing or repairs, request the service shop’s assur-ance that only Factory Authorized Replacement Parts with the same characteris-tics as the original parts have been used, and that the routine safety checkshave been performed to guarantee that the equipment is in safe operating condi-tion.REPLACEMENT WITH UNAUTHORIZED PARTS MAY RESULT IN FIRE,ELECTRIC SHOCK OR OTHER HAZARDS.ATTENTIONPOUR ÉVITER LES CHOC ELECTRIQUES, INTRODUIRE LA LAMELA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON-DANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.CAUTIONTO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUGTO WIDE SLOT FULLY INSERT.If an indoor antenna is used (either built into the set or installed separately),never allow any part of the antenna to touch the metal parts of other electricalappliances such as a lamp, TV set etc.CAUTIONPOWER LINESAny outdoor antenna must be located away from all power lines.OUTDOOR ANTENNA GROUNDINGIf an outside antenna is connected to your tuner or tuner-preamplifier, be surethe antenna system is grounded so as to provide some protection against volt-age surges and built-up static charges. Section 810 of the National ElectricalCode, ANSI/NFPA No. 70-1984, provides information with respect to propergrounding of the mast and supporting structure, grounding of the lead-in wire toan antenna discharge unit, size of grounding conductors, location of antenna dis-charge unit, connection to grounding electrodes and requirements for thegrounding electrode.a. Use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminium, No. 17AWG (1.0mm2) copper-clad steel or bronze wire, or larger, as a ground wire.b. Secure antenna lead-in and ground wires to house with stand-off insulatorsspaced from 4-6 feet (1.22 - 1.83 m) apart.c. Mount antenna discharge unit as close as possible to where lead-in entershouse.d. Use jumper wire not smaller than No.6 AWG (13.3mm2) copper, or the equiva-lent, when a separate antenna-grounding electrode is used. see NEC Section810-21 (j).EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICALCODE INSTRUCTIONS CONTAINED IN ARTICLE 810 - RADIO AND TELEVI-SION EQUIPMENT.NOTE TO CATV SYSTEM INSTALLER: This reminder is provided tocall the CATV system installer’s attention to Article 820-22 of theNational Electrical Code that provides guidelines for proper groundingand, in particular, specifies that the ground cable ground shall be con-nected to the grounding system of the building, as close to the point ofcable entry as practical.CAUTIONRISK OF ELECTRICSHOCK DO NOT OPENATTENTION:RISQUE DE CHOC ELECTRIQUENE PAS OUVRIRCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TOQUALIFIED SERVICE PERSONNELIMPORTANT SAFETY INSTRUCTIONS