NAD T 775 Owner's Manual

Also see for T775: Catalog Owner's manual Datasheet Owner's manual Service manual

NAD T 775 Owner's Manual Manual pdf 8 page image

1 STANDBY BUTTON : Press this button or the HTR 3 remote’s [ON]button to switch ON the T 775. The Standby LED indicator will turn fromamber to blue and illuminate the VFD. Pressing the standby buttonagain turns the unit back to standby mode.The T 775 can also be switched ON from standby mode by pressingany of the front panel buttons. When both Main and Zones are ON,press and hold this button for more than five seconds to place them atstandby mode.NOTESt 5IFSFBSQBOFM108&3TXJUDINVTUCFJOUIF0/QPTJUJPOGPSUIF4UBOECZbutton to activate.t *G"VUP5SJHHFS*/BU5SJHHFS4FUVQNFOVJTBTTJHOFEUPA.BJOPSA"MMBOEUIF53*((&3TXJUDIJTTFUUPA"650NPEF UIFTUBOECZCVUUPOJOUIFGSPOUQBOFMBTXFMMBTUIFDPSSFTQPOEJOH0/0''GVODUJPOLFZTJOUIF)53SFNPUFDPOUSPMXJMMCFEJTBCMFEFòFDUJWFMZIBOEJOHUIJTGVODUJPOUPBOFYUFSOBMDPOUSPMMFS4XJUDI53*((&3UPA0''UPNBJOUBJOOPSNBMQPXFS0/0''GVODUJPOQSPDFEVSFT 4FFTFDUJPOBMTPBCPVUi5SJHHFS4FUVQwVOEFSUIFi4FUVQ.FOVwEJTDVTTJPOT2 STANDBY LED : This indicator will light up amber when the T 775 isin standby state. When the T 775 main or zones are in the ON state,this indicator will illuminate blue. In the unlikely event that the T 775switches to protection state, then this indicator will illuminate red.When infrared command from the HTR 3 is received, this indicator willalso flash momentarily.3 INFO : Repeatedly toggle this button (press/hold first if in Tuner modeand then toggle) to display both at the Vacuum Fluorescent Display(VFD) and On-Screen Display (OSD) the following – Current Source,Volume level, Listening mode, Audio Source Format, Audio Codec,Video Mode and active Zones with their corresponding Source Inputs.While at Tuner mode, toggle this button to cycle through Preset Name,RDS name and RDS text.4 AM/FM/DB : Toggle this button to select either AM, FM, DAB (230Vversion only) or XM (120V version only) tuner functions.5 TUNER MODE : In FM mode, this button will toggle between FMStereo and FM mono. Select FM Mono (FM stereo and FM Mute iconsat VFD are extinguished) for stations that have too much interferenceor are too weak. In DAB (230V version only) or XM (120V version only)radio, this button enables the digital radio menu in conjunction withthe Navigation button and Enter buttons.6 MEMORY : Press this button to store tuned AM, FM and digital radiostations to the T 775’s 40 preset-memory locations. One can store a mixof any AM, FM and digital radio stations to the 40 available presets.7. NAVIGATION and ENTER buttons : These buttons are used tonavigate the T 775 OSD, Tune Scan Forward and Tune Scan Reverse, Preset Skip Forward and Preset Skip Reverse as well asnavigation of DAB (230V version only), XM (120V version only) tunerfunctions and iPod.8 VACUUM FLUORESCENT DISPLAY (VFD): Displays visual informationabout the current settings like the active Source, volume level, listeningmode, audio format, applicable RDS/XM/DAB as well as iPod-relateddisplay information and other related indicators. Refer also to the itemabout DISPLAY SETUP under the USING THE T 775 – SETUP MENUsegment of the OPERATION section.9 REMOTE SENSOR: Point the HTR 3 remote control at the remote sensorand press the buttons. Do not expose the remote sensor of the T 775 toa strong light source such as direct sunlight or illumination. If you do so,you may not be able to operate the T 775 with the remote control.Distance: About 23ft (7m) from the front of the remote sensor.Angle: About 30° in each direction of the front of the remote sensor.IDENTIFICATION OF CONTROLSFRONT PANEL3 4 5 6 7 8 1011 1716151 218 1914131298ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ