6DISASSEMBLY INSTRUCTIONS1. Remove machine screws M 4.0 x 6.0 ( 1 to 6 ) from the side panels.Remove tapping screw 3.0 x 8.5 ( 7 )from the back panel.Refer to Figure No.1.Figure No.12. Pull both sides of the TOP COVER slightly outwards 8 and tilt approx. 35˚ and then removein the direction as indicated by the arrow 9 . Refer to Figure No.2.Figure No.2.7651324988

product safety servicing guidelines

servicing precautions

SPECIFICATIONS

REAR PANEL / FRONT PANEL

DISASSEMBLY INSTRUCTIONS

WIRING DIAGRAM

BLOCK DIAGRAM

INSTRUMENT SETUP

IMPORTANT NOTES

PCB LAYOUT

SCHEMATIC DIAGRAM

IC BLOCK DIAGRAM

ELECTRICAL PARTS LIST

EXPLODED VIEW

EXPLODED VIEW PARTS LIST

PACKING DIAGRAM

NAD T 761 Service Manual

important safety instructions

safety warning

T761

NAD T 761 Service Manual

Product

Learn More

Legal


Contents product safety servicing guidelines servicing precautions Table Of Contents SPECIFICATIONS REAR PANEL / FRONT PANEL DISASSEMBLY INSTRUCTIONS WIRING DIAGRAM BLOCK DIAGRAM INSTRUMENT SETUP IMPORTANT NOTES PCB LAYOUT SCHEMATIC DIAGRAM IC BLOCK DIAGRAM ELECTRICAL PARTS LIST EXPLODED VIEW EXPLODED VIEW PARTS LIST PACKING DIAGRAM	6DISASSEMBLY INSTRUCTIONS1. Remove machine screws M 4.0 x 6.0 ( 1 to 6 ) from the side panels.Remove tapping screw 3.0 x 8.5 ( 7 )from the back panel.Refer to Figure No.1.Figure No.12. Pull both sides of the TOP COVER slightly outwards 8 and tilt approx. 35˚ and then removein the direction as indicated by the arrow 9 . Refer to Figure No.2.Figure No.2.7651324988 Previous Next / 70