NAD C 426 Owner's Manual

Also see for C 426: Owner's manual Specifications Service manual User manual

Contents

NAD C 426 Owner's Manual Manual pdf 5 page image

INTRODUCTIONGETTING STARTEDWHAT’S IN THE BOXPacked with your C 426 you will find· An AM loop antenna.· A FM ribbon-wire antenna with balun.· A detachable AC power cord.· An audio cable connector (RCA-to-RCA lead).· The TNR 1 remote control with 2 (two) AAA batteries.· This owner’s manual version in CD-ROM.SAVE THE PACKAGINGPlease save the box and all of the packaging in which your C 426 arrived.Should you move or otherwise need to transport your C 426, this is by farthe safest container in which to do so. We’ve seen too many otherwiseperfect components damaged in transit for lack of a proper shippingcarton, so please: Save that box!CHOOSING A LOCATIONChoose a location that is well ventilated (with at least several inches to bothsides and behind), and that will provide a clear line of sight, within 23 feet/7meters, between the C 426’s front panel and your primary listening/viewingposition—this will ensure reliable infrared remote control communications.Avoid placing the unit in direct sunlight or near sources of heat and damp.It is perfectly possible to stack the C 426 on top of other components.QUICK STARTIn case you simply cannot wait to experience the performance of yournew C 426, we provide the following “Quick Start” instructions to get youunderway.Please make all the connections to your C 426 with the unit unplugged. It isalso advisable to power down or unplug all associated components whilemaking or breaking any signal or AC power connections.1 Use the RCA-to-RCA lead to connect the left and right output of theC 426 to the tuner input of your amplifier.2 Connect AM and FM antenna.3 Connect the supplied AC cord to the C 426 AC mains input and thenplug into an AC outlet. The Standby LED indicator embedded aroundthe bezel of the STANDBY button will illuminate amber.4 Plug the AC mains plug also of your amplifier into the AC outlet. Powerup your amplifier and set it to the tuner input where the C 426 isconnected.5 Press the front panel STANDBY button to turn ON the C 426. TheStandby LED indicator will turn from amber to blue and illuminate theVFD.6 Toggle front panel’s [FM/AM] button to select AM or FM band.7 Toggle front panel’s [PRESET/TUNE] button to switch between “Preset”and “Tune” mode. Select TUNE mode (“TUNE” scrolls through the VFD).8 Rotate the [PRESET/TUNE] control knob to select desired station.5ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ