|
(Revised 2011-07-21) page 133 of 152Show IGMP routerCommand Name igmp show routerDescription The igmp show router command is used to display the auto-detected routersat present.Syntax igmp show routerParameters NoneExamples N-TRON/Admin#[1]> igmp show routerRouterIp PortNo------------------------192.168.1.150 5NOTES The router display is used to check that the router ip & port number wasreceived correctly.Set IGMP query modeCommand Name igmp set qmodeDescription Set the query mode of the switch to either on, off, or automatic.Syntax igmp set qmode Parameters off | on | autoThere are three different query modes; off, on, and auto.Examples N-TRON/Admin#[1]> igmp set qmode autoNOTES Default: AutoSet IGMP router portCommand Name igmp set rtrportDescription Enable or disable a router port based on a port-range.Syntax igmp set rtrport -range> Parameters port-rangeenter a range of port numbers.enable | disableenable or disable the router port.Examples N-TRON/Admin#[1]> igmp set rtrport 1-4 enableNOTESSet IGMP router modeCommand Name igmp set rtrmodeDescription The igmp show router command is used to display the router group presentin the group listSyntax igmp set rtrmode Parameters none | manual | autoThere are three different router modes available; none, manual, andauto.Examples N-TRON/Admin#[1]> igmp set rtrmode autoNOTES Default: AutoShow IGMP rfilter modeCommand Name igmp show rfilterDescription The igmp show rfilter command is used to display the rfilter status byport(s).Syntax Usage: igmp show rfilter Parameters port-list|allEnter a specific port number list or specify all portsExamples N-TRON/Admin#[22]> Igmp show rfilter allN-TRON/Admin#[22]igmp/show> igmp show rfilter 5
|
