OPTIONALPARTSD2-251Enables operation even when the outside temperature is low.Protect the unit from cold wind.■ PUHZ-ZRP60HA2■ PUHZ-ZRP71VHA21 piece required■ PUHZ-SHW112VHA■ PUHZ-SHW112YHA■ PUHZ-SHW140YHA2 pieces required[R410A type]Air Protect Guide PAC-SH63AG-E *Applicable ModelsDimensions Unit: mm (inch)Alloy hot-dip zinc-coated carbon steelsheetIvory (3.0Y 7.8/1.1)Color (Munsell)MaterialWeight 3.3kgAccessory name x Qty.Washer faced screw (M5x15) x 4plated>Exterior Acrylic resin coatingSurface treatment* model change from PAC-SG57AG-E from Sep 200520025 155130130130 4040R2R2(200)5885844-φ7hole559Outdoor unit installation side559HoleHoleHole(Installation pitch of board B and outdoor unit)(Installation pitch of board B and outdoor unit)■ PUZ-ZM60VHA type■ PUZ-ZM71VHA type[R32 type](for cooling at -15 )* Air Guide prevents reverse rotation of outdoor unit fan when it enters low speed rotation mode with fan controller being operated.It is also used for protection of fan when strong winds, such as a typhoon, wind blowing through tall buildings, etc., directly strike the air outlet.In addition, installation of this product is necessary when cooling opetation is to be performed in outdoor tempreture of -5℃ or lower (down to -15℃).Note the followings when installing this guide:1) Be sure not to use "upward discharge" in a place where snowing is possible. Snow may accumulate in the guard, which could damage the fan, etc.2) Attaching this unit will decrease the performance (by 2-3%) and increase noise from outdoor unit (by approx. 1-2 dB).3) Do not use "upward discharge" when there are any obstacles at the back and on both sides of outdoor unit (air is taken in from top of unit):This could cause a short cycle.4) To eliminate the influence of external wind, be sure to install the unit with its back facing to wall.5) Do not install this unit in a place where wind directly blows to the back of the unit.CAUTIONSpecificationsPhoto DescriptionsOUTDOOR UNIT
