Menu
Mitsubishi Electric PAC-SH29TC-E Installation Manual
  |
●Before starting installation, read the following safety precautions.●The following precautions must be observed as it describes the serious matters for safety.●The safety precautions are described as follows with the degree of danger that occurs when the terminal block is handled wrong.Describes precautions that must be observed to prevent danger of injury or death to the user.Describes precautions that must be observed to prevent damage to the unit.●After installation, make test operation and confirm that it works properlyTell your customers to keep this installation manual together with the operation manual with them, and when they give orsell this machine to other person put this installation manual and operation manual with it.CAUTIONAsk installation to the dealer or an authorised technician.If the terminal block is installed improperly by the customer, water leakage , electric shock, or fire may result.Follow the installation manual to install the terminal block securely.If the terminal block is installed improperly, water leakage , electric shock, or fire or other incidents may result.Electrical wiring must be performed with electrical cables that do not exceed capacity.Short circuit, heat generation, or fire may result.WARNINGWARNINGSafety PrecautionsCAUTIONWARNING1. OutlineThe terminal block is used as a relay to wire an indoor unit and two remote controllers or to wire a remote controller and multi-ple indoor units in order to perform grouping control.2. Applicable modelWall-mounting type (PKA-RP·KAL, PKA-RP·HAL)3. Included partsTerminal block (TB5) ·······1 Screw ·······1 Wire cable ·······1 (240 mm)4. Installation procedurePKA-RP·KAL1). Open the front grille and remove the 2 screws.2). Remove the 3 screw covers and the 3 front panel screws.3). Pull out the bottom of the front panel to the front.Note: Beware that the panel does not contact with the vane while in the procedure.4). Remove the terminal block cover and the control board cover by removing their respective screws.Note: Be sure to keep the washers at hand.Package Air Conditioner Optional PartsRemote Controller Terminal Block Kit Installation ManualModel No: PAC-SH29TC-EScrews (2)Pull out the bottom of the frontpanel to the front.Open the grill andremove the 2 screwsScrew covers & screws (3)Control board coverScrew & washerElectrical box coverScrew & washerContinued overleaf.RG79L644H03 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved