Menu
Mitsubishi Electric MF501C Installation Manual
  |
MITSUBISHI MF501C/MF504C FLEXIBLE DISK DRIVESINSTALLATION GUIDE1. Preparation prior to installation(1) Option jumper settings:The factory pre-settings of the option jumper plugs are shown in Fig. 1.They are set to make the drive plug-in compatible to the IBM PC ~ pC-XT ~and PC-AT ~ (The MF504C is workable only with the PC-AT ~ ) Therefore norelocation of the jumper plugs is required for these and other fully compatiblecomputers. .If your IBM compatible computer requires a unique option setting, or yourcomputer is not IBM compatible, refer to Section 3 in this guide for appro-priate settings.(2) Removing the terminating resistor pack:If your system has another 5 1/.1 inch flexible disk drive installed, remove theterminating resistor pack from the drive connected to the middle connectorof the FDD controller signal cable. The terminator pack of the MF501C orMF504C is located on the P.C. board as seen in Fig. 1.If your other flexible disk drive is a 3.5 inch drive, always remove the termi-nator pack from the MF501Cor MF504C.ME50tCtj: .. I.~l'It:lTERMINATORRESISTORPACME5Q4CFig. 1 Terminator and Jumper Plug Locations2. Cable connection to systemTERMINATORRESISTORPACFig. 2 shows the locations of the signal, power and grounding connectors at therear of the flexible disk drive. |
Related manuals for Mitsubishi Electric MF501C
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved