Mitsubishi Electric LT-3280 Quick Setup Instructions Manual

Also see for LT-3280: Owner's guide Service manual

Contents

Quick Setup InstructionsQuick Setup & Reference GuideLT-3280/LT-3780 LCD Flat Panel HDTV1 Connect Media Center to Display withboth MonitorLink™ cables.#"To operate as a complete HDTV, the displaymust be connected to the media centerusing both required MonitorLink™ cables.Connect TV signal sources: cable wall outlet,HD cable box, HD satellite box, and/or antennas.3 The connections shown in steps 3 and 4 represent a typicalsetup. If your equipment is different, see instructions onconnecting TV signal sources in Chapter 2 of the Owner’sGuide.This is the default settingfor using the remote tocontrol all A/V devicesconnected to the mediacenter and set up withNetCommand®. See theOwner’s Guide for moreinformation.Remove the cover fromthe back of the remotecontrol and insert twoAA batteries, makingsure the (-) and (+)polarities are correct.For best results, insertthe negative (-) side first."" BMLBMJOFCBUUFSJFT""""Insert Remote Control batteries.21 HD Cable or HD SatelliteBox as TV signal source:Connect the 3 Component(YPbPr) video cables and L/Raudio cables to COMP 2 onthe media center.2 TV Antenna or cabledirect from wall outlet asTV signal source: Connectthe RF cable to ANT-1.3 CableCARD™ as TVsignal source: Insert cablecard into the CableCARD™slot and connect cablefrom wall outlet to ANT-1.CableCARD™ must besupported by cable provider.Verify that CABLE/DBS/DTV is selected onthe remote control.3.FEJB$FOUFS57"OUFOOB)%$BCMFPS)%4BUFMMJUF#PY065PSDBCMFEJSFDUGSPNXBMMPVUMFUUP"/557"OUFOOBUP"/5$BCMF$"3%5.PS7*%&04:$ #$37*%&00657*%&04-3!5$)//54 $PNQPOFOU7JEFP-3"VEJP 213

/ 4

Related manuals for Mitsubishi Electric LT-3280