Menu
Manitowoc Multiplex BIC Instructions Manual
    |
InstructionsManitowoc Beverage Systems Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: 812-246-7000, www.manitowocbeverage.com 1 of 492902385/15/15Subject: BIC Blender Motor ReplacementTOOLS REQUIRED• 5/16 Nut Driver• 9 mm Nut Driver (Magnetic)• 7 mm Nut Driver / Open End Wrench• Needle Nose Pliers• Phillips Head Screwdriver• GlovesPRE-INSTALLATIONUnit Preparation.Disassembly1. Remove the right and/or left side panel to gain access to the blender beingreplaced. (See Figure 1)2. Disconnect the blue connector from the blender board. (See Figure 2)3. Remove the blender chamber door of the motor being replaced by lifting thedoor open about a half inch, pulling towards you and down out of it’s track.(See Figure 3)4. Remove blend chamber grate by lifting it up and out of place.5. Push the blender actuator all the way up by reaching into the chamber,carefully grasping the blender assembly and pushing upward. (See Figure 4)! WarningPower OFF the machine and unplug from power source, this unitcontains sharp moving parts. Wear gloves to protect hands.ImportantKeep refrigeration cabinet door closed so that product remainschilled while the unit is OFF.! WarningBe aware the next steps may put hands in contact with the sharpblender blades.FIGURE 1 - Remove PanelFIGURE 3 - Blender Door RemovalFIGURE 2 - Blue ConnectorFIGURE 4 - Push Actuator Up |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved