Menu
Manitowoc FLOMATIC 464 Instructions Manual
  |
InstructionsManitowoc Beverage Systems Sellersburg, 2100 Future Drive, Sellersburg, IN 47172, Tel: 812-246-7000, www.manitowocbeverage.com5031227 REV 25/12Subject: 464 Flow Control Base Kit (5031061)This kit was developed to replace, and correct leaking flow controls on the 454 and464 series valves. Please follow these instructions for installation of this kit.Steps for Replacement:1 Turn power off to valves by turning key switch to the off position.2 Remove the cover from leaking valve.3 Unplug the low voltage connection from valve. (See Figure 1)4 Turn water and syrup off by turning the valve shutoffs on the Back Block to the offposition. (See Figure 2)5 Remove the valve from unit by pulling the Latch pin up then pulling the valve towardyou. (See Figure 3)Once the valve is removed from the unit all valve components must be removed from theexisting flow control base. Save all components removed from valve for reassembly unlessotherwise noted.6 Remove the four screws from the front of the valve that secure the Diffuser block andthe Solenoid Coil Assembly. (See Figure 4)7 Remove the Diffuser block and Solenoid Coil Assembly from valve.8 Remove the two screws that secure the Pallet Retainer Spring and/or Orifice caps to theflow control base. (See Figure 5)9 Remove the Pallet Retainer Spring (if used), both Orifice Caps, and Pallets from the flowcontrol base. (See Figure 6)10 Remove the Pivot Pin, and Coil spring (if used) from Flow Control Base. (See Figure 7)464 Flow Control Base Kit 5031061Part # Description Qty020001284 Screw 8 x 5/8 PH 361004 Retainer Plate 164300 464-GP Flow RateAdjustment25028273 O-Ring 260047G 464 Flow ControlBase1FIGURE 1FIGURE 2FIGURE 3UnplugFIGURE 4SCREWSSCREWS SCREWSFIGURE 5PalletOrifice CapFIGURE 6 FIGURE 7Coil SpringPivot Pin |
Related manuals for Manitowoc FLOMATIC 464
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved