Makita XT269M Instruction Manual

Also see for XDT13: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6 ENGLISHLighting up the front lamp1► 1. LampCAUTION: Do not look in the light or see thesource of light directly.Pull the switch trigger to light up the lamp. The lampkeeps on lighting while the switch trigger is being pulled.The lamp goes out approximately 10 seconds afterreleasing the switch trigger.NOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.Reversing switch action1A B► 1. Reversing switch leverCAUTION: Always check the direction ofrotation before operation.CAUTION: Use the reversing switch only afterthe tool comes to a complete stop. Changing thedirection of rotation before the tool stops may dam-age the tool.CAUTION: When not operating the tool,always set the reversing switch lever to the neu-tral position.This tool has a reversing switch to change the directionof rotation. Depress the reversing switch lever from theA side for clockwise rotation or from the B side for coun-terclockwise rotation.When the reversing switch lever is in the neutral posi-tion, the switch trigger cannot be pulled.ASSEMBLYCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore carrying out any work on the tool.Installing or removing driver bit/socket bit12 mm(15/32”)9 mm(3/8”)Use only the driver bit/socket bit shown in the figure. Donot use any other driver bit/socket bit.1 2► 1. Driver bit 2. SleeveTo install the driver bit, insert it into the sleeve as far asit will go.1 2► 1. Driver bit 2. SleeveTo remove the driver bit, pull the sleeve in the directionof the arrow and pull the driver bit out.