Makita UH5580 Instruction Manual

Also see for UH5580: Instruction manual Instruction manual Technical information Instruction manual Instruction manual

6 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel UH5580 UH6580 UH7580Blade length 550 mm 650 mm 750 mmStrokes per minute (min-1 ) 1,500 1,500 1,500Overall length 970 mm 1,049 mm 1,157 mmNet weight 4.3 - 4.5 kg 4.3 - 4.5 kg 4.3 - 4.5 kgSafety class /II• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2014SymbolThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.Read instruction manual.DOUBLE INSULATIONDo not expose to rain.Remove plug from the mains immediately ifthe cable is damaged or cut.Only for EU countriesDo not dispose of electric equipmenttogether with household waste material! Inobservance of the European Directive, onWaste Electric and Electronic Equipmentand its implementation in accordance withnational law, electric equipment that havereached the end of their life must be col-lected separately and returned to an envi-ronmentally compatible recycling facility.Intended useThe tool is intended for trimming hedges.Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated and can, therefore, also be usedfrom sockets without earth wire.NoiseThe typical A-weighted noise level determined accord-ing to EN60745-2-15:Sound pressure level (LpA ) : 86.5 dB (A)Sound power level (LWA ) : 94.5 dB (A)Uncertainty (K) : 0.7 dB (A)NOTE: The declared noise emission value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared noise emission value(s) mayalso be used in a preliminary assessment of exposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declared val-ue(s) depending on the ways in which the tool is usedespecially what kind of workpiece is processed.WARNING: Be sure to identify safety mea-sures to protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operatingcycle such as the times when the tool is switchedoff and when it is running idle in addition to thetrigger time).VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN60745-2-15:Work mode : hedge trimmingVibration emission (ah ) : 4.4 m/s 2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration total value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared vibration total value(s) may alsobe used in a preliminary assessment of exposure.WARNING: The vibration emission duringactual use of the power tool can differ from thedeclared value(s) depending on the ways in whichthe tool is used especially what kind of workpieceis processed.WARNING: Be sure to identify safety mea-sures to protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operatingcycle such as the times when the tool is switchedoff and when it is running idle in addition to thetrigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.