Makita UB1102 Instruction Manual

3ENGLISH (Original instructions)Explanation of general view1 Switch trigger2 Lock button3 Speed control screw4 Higher5 Lower6 Nozzle7 Blower outlet8 Pin9 Dust bag10 Suction inlet11 Fastener12 Limit mark13 Brush holder cap14 ScrewdriverSPECIFICATIONS• Due to our continuing program of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to EPTA-Procedure 01/2014, are shown in the table.END334-1SymbolsThe followings show the symbols which may be used forthe equipment. Be sure that you understand theirmeaning before use. ENE018-1Intended useThe tool is intended for blowing dust.ENF002-2Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated and can, therefore, also be used fromsockets without earth wire.GEA010-2General Power Tool Safety WarningsWARNING Read all safety warnings, instructions,illustrations and specifications provided with thispower tool. Failure to follow all instructions listed belowmay result in electric shock, fire and/or serious injury.Save all warnings and instructions for futurereference.The term “power tool” in the warnings refers to yourmains-operated (corded) power tool or battery-operated(cordless) power tool.ENB017-2ADDITIONAL SAFETY RULES1. Always use protective goggles, a cap and maskwhen using the blower.2. Never point the nozzle at anyone in the vicinitywhen using the blower.3. Always use the dust bag when collecting dust,chips and the like.Model UB1102 UB1103Capacities Air pressure 5.7 kPa 0 – 5.7 kPaMax. air volume 4.1 m 3 /min 0 – 4.1 m 3/minNo load speed 16,000 min–1 0 – 16,000 min –1Overall length 479 mm 479 mmNet weight 1.9 – 2.2 kgSafety class /IIRead instruction manual.DOUBLE INSULATIONOnly for EU countriesDue to the presence of hazardouscomponents in the equipment, usedelectrical and electronic equipment mayhave a negative impact on the environmentand human health.Do not dispose of electrical and electronicappliances with household waste!In accordance with the European Directiveon waste electrical and electronic equipmentand its adaptation to national law, usedelectrical and electronic equipment shouldbe collected separately and delivered to aseparate collection point for municipal waste,operating in accordance with theenvironmental protection regulations.This is indicated by the symbol of thecrossed-out wheeled bin placed on theequipment.Guaranteed sound power level according toEU Outdoor Noise Directive.Sound power level according to AustraliaNSW Noise Control Regulation