Makita TD111DSAJ Instruction Manual

Also see for TD111D: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

2 ENGLISHSPECIFICATIONSModel: TD111DFastening capacities Machine screw 4 mm - 8 mmStandard bolt 5 mm - 14 mmHigh tensile bolt 5 mm - 12 mmNo load speed Hard impact mode 0 - 3,000 min -1Soft impact mode 0 - 1,300 min -1Impacts per minute Hard impact mode 0 - 3,900 min -1Soft impact mode 0 - 1,600 min -1Rated voltage D.C. 10.8 V - 12 V maxOverall length 135 mmBattery cartridge BL1016, BL1021B BL1041BNet weight 0.97 kg 1.1 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications and battery cartridge may differ from country to country.• Weight, with battery cartridge, according to EPTA-Procedure 01/2003SymbolsThe following show the symbols used for the equip-ment. Be sure that you understand their meaning beforeuse.Read instruction manual.CdNi-MHLi-ionOnly for EU countriesDo not dispose of electric equipment orbattery pack together with household wastematerial!In observance of the European Directives,on Waste Electric and ElectronicEquipment and Batteries and Accumulatorsand Waste Batteries and Accumulatorsand their implementation in accordancewith national laws, electric equipment andbatteries and battery pack(s) that havereached the end of their life must be col-lected separately and returned to an envi-ronmentally compatible recycling facility.Intended useThe tool is intended for screw driving in wood, metaland plastic.NoiseThe typical A-weighted noise level determined accord-ing to EN60745:Sound pressure level (LpA ) : 94 dB(A)Sound power level (LWA ) : 105 dB (A)Uncertainty (K) : 3 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN60745:Work mode: impact tightening of fasteners of the maxi-mum capacity of the toolVibration emission (ah) : 12.5 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.