Makita RP0900 Instruction Manual

Also see for RP0900: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

5are of series production andConforms to the following European Directives:98/37/EC until 28th December 2009 and then with2006/42/EC from 29th December 2009And are manufactured in accordance with the followingstandards or standardised documents:EN60745The technical documentation is kept by our authorisedrepresentative in Europe who is:Makita International Europe Ltd,Michigan, Drive, Tongwell,Milton Keynes, MK15 8JD, England30th January 2009000230Tomoyasu KatoDirectorMakita Corporation3-11-8, Sumiyoshi-cho,Anjo, Aichi, JAPANGEA010-1General Power Tool SafetyWarningsWARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings and instructions forfuture reference. GEB018-2ROUTER SAFETY WARNINGS1. Hold power tools by insulated grippingsurfaces when performing an operation wherethe cutting tool may contact hidden wiring orits own cord. Contact with a "live" wire will makeexposed metal parts of the tool "live" and shockthe operator.2. Use clamps or another practical way to secureand support the workpiece to a stable platform.Holding the work by hand or against your bodyleaves it unstable and may lead to loss of control.3. Wear hearing protection during extendedperiod of operation.4. Handle the bits very carefully.5. Check the bit carefully for cracks or damagebefore operation. Replace cracked ordamaged bit immediately.6. Avoid cutting nails. Inspect for and remove allnails from the workpiece before operation.7. Hold the tool firmly with both hands.8. Keep hands away from rotating parts.9. Make sure the bit is not contacting theworkpiece before the switch is turned on.10. Before using the tool on an actual workpiece,let it run for a while. Watch for vibration orwobbling that could indicate improperlyinstalled bit.11. Be careful of the bit rotating direction and thefeed direction.12. Do not leave the tool running. Operate the toolonly when hand-held.13. Always switch off and wait for the bit to cometo a complete stop before removing the toolfrom workpiece.14. Do not touch the bit immediately afteroperation; it may be extremely hot and couldburn your skin.15. Do not smear the tool base carelessly withthinner, gasoline, oil or the like. They maycause cracks in the tool base.16. Draw attention to the need to use cutters ofthe correct shank diameter and which aresuitable for the speed of the tool.17. Some material contains chemicals which maybe toxic. Take caution to prevent dustinhalation and skin contact. Follow materialsupplier safety data.18. Always use the correct dust mask/respiratorfor the material and application you areworking with.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting the depth of cutFig.1Place the tool on a flat surface. Loosen the screwsecuring the stopper pole.Loosen the lock lever and lower the tool body until the bitjust touches the flat surface. Tighten the lock lever tolock the tool body.Fig.2Next, lower the stopper pole until it makes contact withthe adjusting hex bolt. Align the depth pointer with the