Makita RBC230 Instruction Manual

Also see for RBC260: Service information

4. Hook the bent portion of the nylon cord into thenotch in the center plate of the spool. Wind the nyloncords firmly and snugly on the spool in the directionof the "WIND CORD LH @" engraved on the spool.(Note)Do not wind the nylon cords in the opposite direc-tion of the "WIND CORD LH -'' engraved on thespool. Do not overlap or twist the two nylon cords.They will not feed out properly.5. Wind both nylon cords firmly and snugly until thespool is full to the outer edge of the center plate.Leave approx 120 mm (4.314") of both nylon cordsunwound on the spool. Carefully prevent both nyloncords from coming loose on the spool. Pass the endof the shorter nylon cord out through the hole on theside of the rim of the spool and then back into thehole as illustrated. Pass the end of the other, longernylon cord out through the hole on the opposite sideof the spool as illustrated.6. Pass the end of each nylon cord out through theeyelets on opposite sides of the housing. Place thespool into the housing. Pull the end of nylon cordswhile pressing down the spool.7. Adjust the length of nylon cords so that each nyloncord extends approx. 8 0 mm - 120 mm (3-118" -4-314") out of the housing. If the nylon cord extendsout too much or does not extend out enough, adjustthe length of nylon cord while raising the spoolslightly within the housing.11) 80 mm ~ 1 2 0 mm (3-118'' ~ 4-314")12