5FUNCTIONAL DESCRIPTIONCAUTION: Always be sure that the tool is switched off andunplugged before adjusting or checking functionon the tool.Switch actionCAUTION: Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released. Switch can be locked in "ON" position for ease ofoperator comfort during extended use. Applycaution when locking tool in "ON" position andmaintain firm grasp on tool.12015022To start the tool, simply pull the switch trigger. Releasethe switch trigger to stop.For continuous operation, pull the switch trigger, push inthe lock button and then release the switch trigger.To stop the tool from the locked position, pull the switchtrigger fully, then release it.ASSEMBLYCAUTION: Always be sure that the tool is switched off andunplugged before carrying out any work on thetool.Installing shaft123015023Tighten the shaft into the shaft holder till the hex nutcontacts with the shaft holder.123015024Hold the shaft holder with the wrench and tighten thehex nut with the other wrench in the direction of arrow.Installing mixing blades (country specific)007094To mount the mixing blade, install it with the " UP " markon it facing the tool (directing inside).123007095Install the mixing blade on the top of shaft and secure itwith hex. bolt.Installing top grip (auxiliary handle)015027Screw the top grip on the tool securely.1. Mixing blade2. Shaft3. Hex bolt1. Wrench2. Shaft holder3. Wrench1. Hex nut2. Shaft3. Shaft holder1. Lock button2. Switch trigger