Makita M3602 Instruction Manual

Also see for M3602: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6 ENGLISHSwitch actionCAUTION: Before plugging in the tool, alwayscheck to see that the tool is switched off.CAUTION: Make sure that the shaft lock isreleased before the switch is turned on.To start the tool, move the switch lever to the I position.To stop the tool, move the switch lever to the O position.1Fig.4► 1. Switch leverCAUTION: Hold the tool firmly when turningoff the tool, to overcome the reaction.Electronic functionThe tool is equipped with the electronic functions foreasy operation.Indication lamp1Fig.5► 1. Indication lampThe indication lamp lights up green when the tool isplugged. If the indication lamp does not light up, themains cord or the controller may be defective. The indi-cation lamp is lit but the tool does not start even if thetool is switched on, the carbon brushes may be wornout, or the controller, the motor or the ON/OFF switchmay be defective.Unintentional restart proofThe tool does not start with the switch lever is in the Iposition even when the tool is plugged.At this time, the indication lamp blinks in red and showsthe unintentional restart proof device is on function.To cancel the unintentional restart proof, move theswitch lever to the O position.Soft start featureSoft-start feature minimizes start-up shock, and makesthe tool start smoothly.ASSEMBLYCAUTION: Always be sure that the tool isswitched off and unplugged before carrying outany work on the tool.Installing or removing the router bitInsert the router bit all the way into the collet cone.Press the shaft lock to keep the shaft stationary anduse the wrench to tighten the collet nut securely. Whenusing router bits with smaller shank diameter, first insertthe appropriate collet sleeve into the collet cone, theninstall the router bit.To remove the router bit, follow the installation proce-dure in reverse.1234Fig.6► 1. Shaft lock 2. Wrench 3. Loosen 4. TightenCAUTION: Install the router bit securely.Always use only the wrench provided with thetool. A loose or overtightened router bit can bedangerous.NOTICE: Do not tighten the collet nut withoutinserting a router bit or install small shank bitswithout using a collet sleeve. Either can lead tobreakage of the collet cone.